This is an accurate reproduction of the Ford RS2000 (MkI & MkII Escort) alloy bellhousing with optional quick release facility.
The small dimensions of this bellhousing allows fitment of the engines and gearboxes listed below without the need to modify the bulkhead or transmission tunnel.
Please note that the clutch cable locating boss is integral to the standard RS2000 alloy sump. If this bellhousing is to be used in an application utilising anything other than a standard RS2000 alloy sump (i.e. with a steel sump) AF1A Clutch Cable Adaptor Plate will be required also.
The quick release option allows quicker gearbox removal and fitting by moving the 4 internal gearbox to bellhousing bolts to the outside of the gearbox. This allows the gearbox to be removed whilst leaving the bellhousing in place, making a difficult job much easier. The gearbox is attached to the bellhousing using the original bolts or 10mm cap head screws fitted from the rear of the bellhousing face of the gearbox *.
The RS2000 Clutch Fork and RS2000 Clutch Release Bearing may also be required.
You may also be interested in our Ford Pinto Lightweight Steel Flywheel.
Specification and Application
||Reproduction RS2000 alloy bellhousing
Machined on front and rear faces
Tapped to take standard clutch fork (not included)
|Gearbox to Engine Face
||7 inch (178mm)
||Ford 1.6/2.0 SOHC (Pinto)
Ford 1.3/1.6 x/flow
Ford pre x/flow
Lotus Twin Cam
Ford Zetec 1.6/1.8/2.0
N/A Cosworth **
BDA series ***
||Ford Type E (Rocket) 4 speed
Ford Type 9 (Sierra) 5 speed ****
Rally/Race - MkI/II Escort, Sierra, Lotus Cortina
* Bolts pass through the original 12mm threaded bolt holes in the gearbox for a "clearance fit"; it may be necessary to grind a small amount of the gearbox material away in order to clear the bolt heads; the bellhousing is pre-tapped to accept these bolts
** Requires smaller 9 bolt flywheel if using standard crankshaft
*** The starter motor may foul the sump on certain models (ie big wing sump)
**** 2.0l only; the 2.8l gearbox requires an additional adaptor plate due to the longer 1st motion shaft