This bellhousing is a direct replacement for the cast iron Ford Sierra item. Based on our Cable Clutch Bellhousing  but redesigned for hydraulic actuation, retaining the cable release arm.

Requires internally mounted slave cylinder.

It can be used for the same engine / gearbox combinations as for the RS2000 Type Bellhousing but with the starter motor on the left hand side.

You may also need the spigot bearing that fits directly in the end of the crankshaft.

Specification and Application

* Requires smaller 9 bolt flywheel if using standard crankshaft
** 2.0l only; the 2.8l gearbox requires an additional adaptor plate due to the longer 1st motion shaft