Machined to order (lead time approximately 10 days).
You may also need the spigot bearing that fits directly in the end of the crankshaft. The RS2000 Clutch Fork and RS2000 Clutch Release Bearing may also be required. if using these you will require the Clutch Cable Adapter Plate
You may also be interested in our Ford Pinto Lightweight Steel Flywheel.
Please see these related products below.
Specification and Application
|Component||Pinto or Cosworth to Borg Warner T5|
Machined on front and rear faces
Tapped to take standard clutch fork (not included)
|Gearbox to engine face||7 inch (178mm)|
|Widest point on front face||400mm|
|Engines||Ford 1.6/2.0 SOHC (Pinto)
Ford 1.3/1.6 x/flow
Ford pre x/flow
Lotus Twin Cam
Ford Zetec 1.6/1.8/2.0 *
N/A Cosworth **
BDA series ***
|Gearboxes||Borg Warner T5 **** Borg Warner T5 information|
Rally/Race – MkI/II Escort, Sierra, Lotus Cortina
* Please see the FAQs question six for provisos when using the Zetec E engine
** Requires smaller 9 bolt flywheel if using standard crankshaft
*** The starter motor may foul the sump on certain models (ie big wing sump)
**** Fits Sierrra Cosworth T5. The TVR gearbox flange is 4mm smaller in diameter and so will need spacing out. Mustang T5 has a different spline input shaft.
If using a USA or Australian T5 gearbox you may need our 10 spline 1 1/16″ clutch friction plate
Very impressed with the service from start to finish, not sure if it fits yet but the quality of the product looks great.