16 Valve Astra Inlet Manifold
16 Valve Astra Inlet Manifold
£115.50
To convert 16 Valve Astra 2.0XE engine to twin Weber 40 or 45 carburettors. Studs & nuts included. Cosworth type mount ‘o’ ring plates not included. * Please note that the manifold is only compatible with 0 degrees mounted engines, not 7 degree standard angle.
Products that you might find interesting
Vauxhall 2.0XE Engine to Ford Gearbox Cable Clutch Bellhousing 7 Degrees
Vauxhall 2.0XE Engine to Ford Gearbox Cable Clutch Bellhousing 7 Degrees
Vauxhall 2.0XE Engine to Ford Gearbox Cable Clutch Bellhousing 7 Degrees
Vauxhall 2.0XE Engine to Ford Gearbox Cable Clutch Bellhousing 7 DegreesThis bellhousing allows the Vauxhall 2.0XE Engine to be connected to the Ford Type E (Rocket 4 sp) and Type 9 (Sierra 5 sp) gearboxes using a cable clutch. The bellhousing allows the engine to be located in its original 7 degree position.
Westfield Duratec Engine Mounting Kit
Westfield Duratec Engine Mounting KitA complete Westfield Engine Mounting Kit
Zetec RWD Starter Motor
Zetec RWD Starter MotorThis starter motor can be used in conjunction with the RS2000 Type Bellhousing (cable clutch), the Sierra Direct Replacement Cable Clutch Bellhousing and Sierra Direct Replacement Hydraulic Clutch Bellhousing bellhousings. Equivalent to LRS707.
NOTE
This starter motor has 10mm less pinion offset to accommodate a standard Zetec E fitted to a Ford Type 9 or Borg Warner T5. Please note that some aftermarket lightweight flywheels are manufactured with a different offset to allow the fitment of standard Pinto or X-flow starter motors. Please check that your flywheel is the standard Zetec E item.
Zetec SE or Sigma Billet Steel Oil Pump Gear Set
Zetec SE or Sigma Billet Steel Oil Pump Gear Set
Zetec SE or Sigma Billet Steel Oil Pump Gear Set
Zetec SE or Sigma Billet Steel Oil Pump Gear SetNew Billet steel oil pump gear set to suit the Ford Zetec SE, Sigma and TI VCT engines.
Duratec Underdrive Pulley 146mm Trigger Wheel
Duratec Underdrive Pulley 146mm Trigger WheelReplaces the standard crank pulley on 2.0 and 2.3 litre Duratec engines for higher revving competition engines. Save valuable horsepower by avoiding over-spinning belt driven ancillaries.
Duratec Water Manifold
Duratec Water ManifoldDesigned to simplify the cooling system when used in a longitudinal engine position. The depth from the rear cylinder head face is 60mm. Incorporates heater outlet. Comes with temperature gauge sender.
